Skip to content
Fault code dictionary (DTC)

B1508 — Flash-to-pass switch circuit open

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control module has detected that the circuit of the high beam flash switch is broken, so the signal does not arrive. This code is manufacturer-defined and the detail can vary by model. When you operate the switch, the module receives nothing.
FamilyBody (B)

Typical symptoms

High beam flash does not respond
Normal high beams may still work
The switch works only sometimes
Fault that appears when turning the wheel or moving the stalk
Lighting warning light or message on the dashboard

Common causes

Broken wire or unplugged connector behind the steering wheel
Worn or corroded switch contacts
Broken or worn clockspring (rotating contact) in the steering wheel
Faulty steering column stalk
Faulty body control module (rare)

What to do

Check whether the fault only appears at certain steering wheel positions, because that points to the wiring or clockspring. It does not prevent driving, but have it checked without too much delay: the overtaking signal is still a useful safety feature.

How to read code B1508

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code B1508 starts with B: it belongs to the body (airbags, comfort, lights) area. It is defined by the manufacturer, so the exact meaning can change from make to make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code B1508 mean?

Flash-to-pass switch circuit open. The control module has detected that the circuit of the high beam flash switch is broken, so the signal does not arrive. This code is manufacturer-defined and the detail can vary by model. When you operate the switch, the module receives nothing.

Can I keep driving with code B1508 active?

With caution: limp mode possible, have it checked soon

Common causes — B1508

Broken wire or unplugged connector behind the steering wheel Worn or corroded switch contacts Broken or worn clockspring (rotating contact) in the steering wheel Faulty steering column stalk Faulty body control module (rare)

How do you fix code B1508?

Check whether the fault only appears at certain steering wheel positions, because that points to the wiring or clockspring. It does not prevent driving, but have it checked without too much delay: the overtaking signal is still a useful safety feature.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes