Skip to content
Fault code dictionary (DTC)

B1727 — Driver seat rear up switch circuit shorted to battery voltage

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control module has detected battery voltage on the circuit of the switch that raises the rear of the driver's seat when there should not be any. The code is manufacturer-defined and the exact meaning can vary by brand. It usually points to a wire touching a power supply or to a stuck switch.
FamilyBody (B)

Typical symptoms

The rear of the seat rises without you pressing anything
The seat keeps moving or runs to the end of its travel
The control does not respond
Other abnormal seat movements
Possible body warning light or message, depending on the model

Common causes

Seat switch stuck in the pressed position
Wire with damaged insulation touching a power cable
Liquid inside the switch pack
Damaged connector under the seat
Faulty seat control module (uncommon)

What to do

If the seat moves by itself, don't adjust it while driving and keep the space around it clear. Have the switch pack and the wiring under the seat checked. If the motor keeps running it can drain the battery or overheat, so don't leave it for long.

How to read code B1727

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code B1727 starts with B: it belongs to the body (airbags, comfort, lights) area. It is defined by the manufacturer, so the exact meaning can change from make to make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code B1727 mean?

Driver seat rear up switch circuit shorted to battery voltage. The control module has detected battery voltage on the circuit of the switch that raises the rear of the driver's seat when there should not be any. The code is manufacturer-defined and the exact meaning can vary by brand. It usually points to a wire touching a power supply or to a stuck switch.

Can I keep driving with code B1727 active?

With caution: limp mode possible, have it checked soon

Common causes — B1727

Seat switch stuck in the pressed position Wire with damaged insulation touching a power cable Liquid inside the switch pack Damaged connector under the seat Faulty seat control module (uncommon)

How do you fix code B1727?

If the seat moves by itself, don't adjust it while driving and keep the space around it clear. Have the switch pack and the wiring under the seat checked. If the motor keeps running it can drain the battery or overheat, so don't leave it for long.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes