B2314 — Passenger mirror horizontal sensor circuit shorted to battery voltage
| Meaning | The control module has detected too high a voltage on the circuit of the passenger mirror's horizontal position sensor, as if the wire were touching battery positive. The code is manufacturer-defined, so the exact logic can vary by brand. The position signal is therefore false and unusable. |
| Family | Body (B) |
Typical symptoms
The mirror runs to the end of its travel and stops
Stored positions are not respected
Motor noise that keeps going without moving the mirror
A fault message on the dash, on some models
Common causes
Water or moisture in the connector or mirror assembly
Faulty internal potentiometer
Damaged connector with terminals touching each other
Faulty door or body control module, less common
What to do
How to read code B2314
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code B2314 starts with B: it belongs to the body (airbags, comfort, lights) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code B2314 mean?
Passenger mirror horizontal sensor circuit shorted to battery voltage. The control module has detected too high a voltage on the circuit of the passenger mirror's horizontal position sensor, as if the wire were touching battery positive. The code is manufacturer-defined, so the exact logic can vary by brand. The position signal is therefore false and unusable.
Can I keep driving with code B2314 active?
With caution: limp mode possible, have it checked soon
Common causes — B2314
Wire with damaged insulation touching a live wire Water or moisture in the connector or mirror assembly Faulty internal potentiometer Damaged connector with terminals touching each other Faulty door or body control module, less common
How do you fix code B2314?
Look carefully at the mirror connector and wiring for moisture, corrosion or damaged insulation. Avoid pressing the switch repeatedly if you hear the motor straining, so you don't damage it. Have it checked within a reasonable time.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: B2313 — Passenger mirror horizontal position sensor circui...
- Next code: B2315 — Passenger mirror horizontal sensor circuit shorted...
Related codes
- B2300 — Driver seat memory position error
- B2301 — Passenger seat memory position error
- B2302 — Seat headrest feedback potentiometer circuit failure
- B2303 — Seat headrest feedback potentiometer circuit open
- B2304 — Seat headrest potentiometer circuit short to battery
- B2305 — Seat headrest potentiometer circuit short to ground
- B2306 — Seat headrest motor stalled
- B2310 — Driver mirror memory position error
- B2311 — Passenger mirror memory position error
- B2312 — Passenger mirror horizontal position sensor circuit fault
- B2313 — Passenger mirror horizontal position sensor circuit open
- B2315 — Passenger mirror horizontal sensor circuit shorted to ground