Skip to content
Fault code dictionary (DTC)

P030F — Ignition B control signal circuit high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer detected a higher voltage than expected on the control circuit of ignition "B". Which coil or coil group the letter B refers to is decided by each manufacturer, so you need the wiring diagram for your make to be certain. The fault is electrical, in the control signal or the wiring.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Rough or jerky running
Loss of power
Hard starting
Possible limp mode with reduced performance

Common causes

Coil control wire touching a power supply
Corroded or damaged connector at the coil or computer
Faulty coil or ignition module
Ground connection of the circuit loose or poor
Internal computer fault (uncommon)

What to do

First inspect the connectors and wiring of the affected coil, looking for pinched, burnt or wet wires. If the coil or module is suspect, an electrical test with a proper tool is needed. Don't put it off for long, because a coil that isn't working properly can damage the catalytic converter.

How to read code P030F

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P030F starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (0F) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P030F mean?

Ignition B control signal circuit high. The engine computer detected a higher voltage than expected on the control circuit of ignition "B". Which coil or coil group the letter B refers to is decided by each manufacturer, so you need the wiring diagram for your make to be certain. The fault is electrical, in the control signal or the wiring.

Can I keep driving with code P030F active?

With caution: limp mode possible, have it checked soon

Common causes — P030F

Coil control wire touching a power supply Corroded or damaged connector at the coil or computer Faulty coil or ignition module Ground connection of the circuit loose or poor Internal computer fault (uncommon)

How do you fix code P030F?

First inspect the connectors and wiring of the affected coil, looking for pinched, burnt or wet wires. If the coil or module is suspect, an electrical test with a proper tool is needed. Don't put it off for long, because a coil that isn't working properly can damage the catalytic converter.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes