Skip to content
Fault code dictionary (DTC)

P0336 — Crankshaft Position Sensor A Circuit Range/Performance

Severity: Serious Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningYour car's computer detected that the signal coming from the crankshaft position sensor does not match the expected pattern or timing. This sensor tells the engine brain where the pistons are so it knows when to spark and inject fuel.
FamilyPowertrain (P)

Typical symptoms

The engine takes longer than usual to start
The car suddenly stalls while driving
The engine runs rough or misfires

Common causes

The sensor connector is loose, dirty, or damaged
The sensor itself is failing internally
The reluctor wheel on the crankshaft has physical damage or debris buildup
Wiring harness damage between the sensor and the engine computer

What to do

You should check the wiring and the connector attached to the crankshaft sensor first, as they often get exposed to heat and oil leaks. It is best to look into this soon because an unstable crankshaft signal can leave you stranded if the engine stops starting altogether.

How to read code P0336

This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.

The code P0336 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (36) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0336 mean?

Crankshaft Position Sensor A Circuit Range/Performance. Your car's computer detected that the signal coming from the crankshaft position sensor does not match the expected pattern or timing. This sensor tells the engine brain where the pistons are so it knows when to spark and inject fuel.

Can I keep driving with code P0336 active?

With caution: limp mode possible, have it checked soon

Common causes — P0336

The sensor connector is loose, dirty, or damaged The sensor itself is failing internally The reluctor wheel on the crankshaft has physical damage or debris buildup Wiring harness damage between the sensor and the engine computer

How do you fix code P0336?

You should check the wiring and the connector attached to the crankshaft sensor first, as they often get exposed to heat and oil leaks. It is best to look into this soon because an unstable crankshaft signal can leave you stranded if the engine stops starting altogether.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes