Skip to content
Fault code dictionary (DTC)

P0340 — Camshaft Position Sensor Circuit Malfunctioning

Severity: Serious Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer has lost the proper signal from the camshaft position sensor. This sensor tells the computer exactly where the valves are, which is necessary to inject fuel and spark at the right moment.
FamilyPowertrain (P)

Typical symptoms

The engine cranks longer than usual before finally starting
The engine stalls unexpectedly while driving or idling
The vehicle lacks normal power or runs rough
The check engine light is turned on

Common causes

Faulty camshaft position sensor
Damaged, corroded, or loose wiring and electrical connectors
Worn timing chain or belt affecting sensor alignment
Internal failure inside the engine computer

What to do

Have a mechanic check the wiring harness and the sensor connector first, as poor electrical contact is very common. You should address this soon because it can leave you stranded if the engine stops starting altogether.
Full guide: P0340: meaning, causes and solutions

How to read code P0340

This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.

The code P0340 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (40) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0340 mean?

Camshaft Position Sensor Circuit Malfunctioning. The engine computer has lost the proper signal from the camshaft position sensor. This sensor tells the computer exactly where the valves are, which is necessary to inject fuel and spark at the right moment.

Can I keep driving with code P0340 active?

With caution: limp mode possible, have it checked soon

Common causes — P0340

Faulty camshaft position sensor Damaged, corroded, or loose wiring and electrical connectors Worn timing chain or belt affecting sensor alignment Internal failure inside the engine computer

How do you fix code P0340?

Have a mechanic check the wiring harness and the sensor connector first, as poor electrical contact is very common. You should address this soon because it can leave you stranded if the engine stops starting altogether.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes