Skip to content
Fault code dictionary (DTC)

P060F — Internal control module coolant temperature check fault

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit internally checks the coolant temperature signal and found an error in its own check. The temperature is used to meter fuel and to manage the fan and cold starts. The sensor is not necessarily bad: the code points at a problem in how the data is processed.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Hard cold starting
Fan always running or never running
Odd temperature gauge
Unusual fuel use and smoke

Common causes

Faulty temperature sensor or poor wiring
Corroded connector
Disturbed sensor supply
Software needing an update
Internal failure of the control unit

What to do

Have the sensor and its wiring checked, comparing the reported temperature with the real one. If the temperature gauge is wrong, check the coolant level often and do not let the engine overheat.

How to read code P060F

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P060F starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (0F) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P060F mean?

Internal control module coolant temperature check fault. The control unit internally checks the coolant temperature signal and found an error in its own check. The temperature is used to meter fuel and to manage the fan and cold starts. The sensor is not necessarily bad: the code points at a problem in how the data is processed.

Can I keep driving with code P060F active?

With caution: limp mode possible, have it checked soon

Common causes — P060F

Faulty temperature sensor or poor wiring Corroded connector Disturbed sensor supply Software needing an update Internal failure of the control unit

How do you fix code P060F?

Have the sensor and its wiring checked, comparing the reported temperature with the real one. If the temperature gauge is wrong, check the coolant level often and do not let the engine overheat.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes