P060E — Internal control module throttle position check fault
| Meaning | The control unit internally verifies the electronic throttle valve signals and found an error in its own check. If it is not sure of the throttle position, it cuts power for safety. The code alone does not say whether the fault is in the throttle body or in the control unit. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power
Unstable or high idle
Slow response to the accelerator
Engine stalling at low speed
Common causes
Poor throttle connector or wiring
Disturbed sensor supply
Software needing an update
Internal failure of the control unit
What to do
How to read code P060E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P060E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (0E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P060E mean?
Internal control module throttle position check fault. The control unit internally verifies the electronic throttle valve signals and found an error in its own check. If it is not sure of the throttle position, it cuts power for safety. The code alone does not say whether the fault is in the throttle body or in the control unit.
Can I keep driving with code P060E active?
With caution: limp mode possible, have it checked soon
Common causes — P060E
Dirty throttle body or worn position sensor Poor throttle connector or wiring Disturbed sensor supply Software needing an update Internal failure of the control unit
How do you fix code P060E?
Have the throttle body, connector and wiring checked, along with its relearn procedure after cleaning or replacement. If power is reduced or the engine stalls, avoid using the car in traffic.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P060D — Internal control module accelerator pedal check fa...
- Next code: P060F — Internal control module coolant temperature check...
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault