P063E — Auto configuration: throttle input not present, bank 1
| Meaning | At start-up, or after a component has been replaced, the control unit tries to configure itself automatically according to the connected components. In this case it cannot find the bank 1 throttle signal. The exact meaning and how the configuration is carried out depend on the manufacturer, so this does not apply equally to every make. |
| Family | Powertrain (P) |
Typical symptoms
Engine will not start or starts with difficulty
Limited power or limp mode
Abnormal accelerator response
Irregular idle
Common causes
Broken wiring to the throttle body
Faulty throttle body or its sensor
Control unit replaced or reprogrammed incompletely
Supply or earth problem in the circuit
Faulty control unit
What to do
How to read code P063E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P063E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (3E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P063E mean?
Auto configuration: throttle input not present, bank 1. At start-up, or after a component has been replaced, the control unit tries to configure itself automatically according to the connected components. In this case it cannot find the bank 1 throttle signal. The exact meaning and how the configuration is carried out depend on the manufacturer, so this does not apply equally to every make.
Can I keep driving with code P063E active?
With caution: limp mode possible, have it checked soon
Common causes — P063E
Throttle connector disconnected or corroded Broken wiring to the throttle body Faulty throttle body or its sensor Control unit replaced or reprogrammed incompletely Supply or earth problem in the circuit Faulty control unit
How do you fix code P063E?
First check that the throttle connector is fully seated and free of corrosion. If the code appeared after work on the car, tell the workshop. With limited power, drive carefully and have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P063D — Generator voltage sense high
- Next code: P063F — Auto configuration: coolant temperature input not...
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault