Skip to content
Fault code dictionary (DTC)

P063F — Auto configuration: coolant temperature input not present

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningAt start-up, or after a component has been replaced, the control unit tries to configure itself automatically according to the connected components. In this case it cannot find the coolant temperature sensor signal. The exact meaning and how the configuration is carried out depend on the manufacturer, so it does not apply equally to every make.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Hard cold starting
Cooling fan running all the time
Temperature gauge stuck or erratic
Abnormal fuel use and exhaust smoke
Irregular idle

Common causes

Temperature sensor connector disconnected or corroded
Sensor wiring broken or shorted
Faulty temperature sensor
Control unit replaced or reprogrammed incompletely
Faulty control unit

What to do

Check the coolant temperature sensor connector and wires, which is usually easy to reach. Without this data the control unit cannot manage mixture and fan properly: have it checked soon, to avoid undetected overheating.

How to read code P063F

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P063F starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (3F) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P063F mean?

Auto configuration: coolant temperature input not present. At start-up, or after a component has been replaced, the control unit tries to configure itself automatically according to the connected components. In this case it cannot find the coolant temperature sensor signal. The exact meaning and how the configuration is carried out depend on the manufacturer, so it does not apply equally to every make.

Can I keep driving with code P063F active?

With caution: limp mode possible, have it checked soon

Common causes — P063F

Temperature sensor connector disconnected or corroded Sensor wiring broken or shorted Faulty temperature sensor Control unit replaced or reprogrammed incompletely Faulty control unit

How do you fix code P063F?

Check the coolant temperature sensor connector and wires, which is usually easy to reach. Without this data the control unit cannot manage mixture and fan properly: have it checked soon, to avoid undetected overheating.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes