P0640 — Intake air heater control circuit fault
| Meaning | The control unit has detected a fault in the circuit that controls the intake air heater, a component that warms the incoming air to help cold starting, used mainly on diesels. The code is generic and does not specify the exact nature of the fault. |
| Family | Powertrain (P) |
Typical symptoms
Hard cold starting
White or grey smoke on start-up
Rough running in the first few minutes
Noisier running when cold
Common causes
Corroded or damaged connector or wiring
Heating element open or shorted
Supply or earth problem in the circuit
Control unit with a faulty output
What to do
How to read code P0640
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0640 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (40) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0640 mean?
Intake air heater control circuit fault. The control unit has detected a fault in the circuit that controls the intake air heater, a component that warms the incoming air to help cold starting, used mainly on diesels. The code is generic and does not specify the exact nature of the fault.
Can I keep driving with code P0640 active?
With caution: limp mode possible, have it checked soon
Common causes — P0640
Faulty relay or fuse for the heater Corroded or damaged connector or wiring Heating element open or shorted Supply or earth problem in the circuit Control unit with a faulty output
How do you fix code P0640?
Check the circuit fuses and relay and the condition of the connectors. In mild weather the car may run normally, but starting gets worse in the cold: do not wait for the first frosts to have it checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P063F — Auto configuration: coolant temperature input not...
- Next code: P0641 — Sensor reference voltage: circuit open
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault