Skip to content
Fault code dictionary (DTC)

P06B2 — Sensor power supply A: voltage too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe reference voltage on sensor branch "A" is higher than expected. It can come from a supply wire touching another higher-voltage line, or from a control module fault. Which sensors are on branch A depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Nonsensical or unstable sensor readings
Loss of power
Limp mode
Several sensor codes at once

Common causes

Supply wire touching a 12-volt line
Damaged or poorly repaired wiring
Connector with bent or shorted pins
Internal control module fault
Problems with the control module ground circuit

What to do

Check the wiring and connectors of the sensors involved, looking for chafing, burn marks or poor repairs. If there has been recent work in the engine bay, start there. Get it diagnosed with proper equipment soon, because abnormal voltage can damage sensors.

How to read code P06B2

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P06B2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (B2) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P06B2 mean?

Sensor power supply A: voltage too high. The reference voltage on sensor branch "A" is higher than expected. It can come from a supply wire touching another higher-voltage line, or from a control module fault. Which sensors are on branch A depends on the manufacturer.

Can I keep driving with code P06B2 active?

With caution: limp mode possible, have it checked soon

Common causes — P06B2

Supply wire touching a 12-volt line Damaged or poorly repaired wiring Connector with bent or shorted pins Internal control module fault Problems with the control module ground circuit

How do you fix code P06B2?

Check the wiring and connectors of the sensors involved, looking for chafing, burn marks or poor repairs. If there has been recent work in the engine bay, start there. Get it diagnosed with proper equipment soon, because abnormal voltage can damage sensors.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes