P06B3 — Sensor power supply B: open circuit or fault
| Meaning | The control module supplies a reference voltage to sensors. On supply "B", a second branch separate from branch A, it has detected an open circuit or a fault. Which sensors are on branch B depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Engine running rough or jerking
Loss of power
Limp mode
Several different sensor codes at once
Common causes
A faulty or unplugged sensor on branch B
Corrosion in the connectors
Damaged wiring harness
Internal control module fault
What to do
How to read code P06B3
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P06B3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (B3) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P06B3 mean?
Sensor power supply B: open circuit or fault. The control module supplies a reference voltage to sensors. On supply "B", a second branch separate from branch A, it has detected an open circuit or a fault. Which sensors are on branch B depends on the manufacturer.
Can I keep driving with code P06B3 active?
With caution: limp mode possible, have it checked soon
Common causes — P06B3
Broken wire or loose connector on the supply branch A faulty or unplugged sensor on branch B Corrosion in the connectors Damaged wiring harness Internal control module fault
How do you fix code P06B3?
If several different sensor codes appear together, suspect this shared supply. Check the connectors and wiring of the sensors on branch B, for which you need your car's wiring diagram. If the car loses power or stalls, get it diagnosed without delay.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P06B2 — Sensor power supply A: voltage too high
- Next code: P06B4 — Sensor power supply B: voltage too low
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault