Skip to content
Fault code dictionary (DTC)

P06B4 — Sensor power supply B: voltage too low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe reference voltage the control module sends to the sensors on branch "B" is lower than expected. Usually the cause is a short to ground along that branch or a faulty sensor. Which sensors sit on branch B varies by manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Loss of power
Irregular running or stalling
Limp mode
Several sensor codes at once

Common causes

A faulty sensor shorting the supply
Supply wire pinched or touching ground
Wet or corroded connector
Damaged wiring harness
Internal control module fault

What to do

Check the visible wiring and the connectors of the sensors on branch B first. To find the shorted sensor, a workshop unplugs them one at a time with the engine off, following the diagram. If the car goes into limp mode or stalls, don't use it until it is sorted.

How to read code P06B4

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P06B4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (B4) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P06B4 mean?

Sensor power supply B: voltage too low. The reference voltage the control module sends to the sensors on branch "B" is lower than expected. Usually the cause is a short to ground along that branch or a faulty sensor. Which sensors sit on branch B varies by manufacturer.

Can I keep driving with code P06B4 active?

With caution: limp mode possible, have it checked soon

Common causes — P06B4

A faulty sensor shorting the supply Supply wire pinched or touching ground Wet or corroded connector Damaged wiring harness Internal control module fault

How do you fix code P06B4?

Check the visible wiring and the connectors of the sensors on branch B first. To find the shorted sensor, a workshop unplugs them one at a time with the engine off, following the diagram. If the car goes into limp mode or stalls, don't use it until it is sorted.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes