P06DF — Glow plug control module 1: memory checksum error
| Meaning | The module that controls the pre-heating glow plugs of diesel engines ran a check on its own internal memory and the result is not correct (checksum error). In practice the data stored in the module may be corrupted. This does not necessarily mean the glow plugs themselves are faulty. |
| Family | Powertrain (P) |
Typical symptoms
Hard starting when cold
White or grey smoke at start-up
Uneven running in the first minutes
Glow plugs not switching on or staying on too long
Common causes
Unstable supply voltage or weak battery
Power interruption during a software update
Poor connectors or grounds on the module
Module software needing an update, if the manufacturer provides one
What to do
How to read code P06DF
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P06DF starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (DF) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P06DF mean?
Glow plug control module 1: memory checksum error. The module that controls the pre-heating glow plugs of diesel engines ran a check on its own internal memory and the result is not correct (checksum error). In practice the data stored in the module may be corrupted. This does not necessarily mean the glow plugs themselves are faulty.
Can I keep driving with code P06DF active?
With caution: limp mode possible, have it checked soon
Common causes — P06DF
Internal fault in the glow plug module Unstable supply voltage or weak battery Power interruption during a software update Poor connectors or grounds on the module Module software needing an update, if the manufacturer provides one
How do you fix code P06DF?
First check the battery, supply and grounds of the module, then re-read the code after noting it down: if it returns, the module probably needs replacing or reprogramming. If the car starts well it can be used with care, but in winter starting may become difficult.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P06DE — Oil pressure control: regulator stuck in the on po...
- Next code: P06E0 — Cylinder 11 glow plug control circuit: voltage too...
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault