P06E0 — Cylinder 11 glow plug control circuit: voltage too low
| Meaning | The control module detected a lower-than-expected voltage on the glow plug control circuit of cylinder 11, often because of a short to ground. This code applies to diesel engines with at least 11 cylinders, which are very rare. On an ordinary car, check that the code was read correctly and which cylinder numbering the manufacturer uses. |
| Family | Powertrain (P) |
Typical symptoms
Hard starting when cold
White or grey smoke after start-up
Uneven running of one cylinder in the first minutes
Glow plug of cylinder 11 not heating
Common causes
Glow plug with an internal short
Dirty, wet or corroded connector
Wiring damaged by heat or chafing
Internal fault in the glow plug module
What to do
How to read code P06E0
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P06E0 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (E0) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P06E0 mean?
Cylinder 11 glow plug control circuit: voltage too low. The control module detected a lower-than-expected voltage on the glow plug control circuit of cylinder 11, often because of a short to ground. This code applies to diesel engines with at least 11 cylinders, which are very rare. On an ordinary car, check that the code was read correctly and which cylinder numbering the manufacturer uses.
Can I keep driving with code P06E0 active?
With caution: limp mode possible, have it checked soon
Common causes — P06E0
Control wire in contact with ground Glow plug with an internal short Dirty, wet or corroded connector Wiring damaged by heat or chafing Internal fault in the glow plug module
How do you fix code P06E0?
First check the wiring and connector of the indicated glow plug, then measure the glow plug resistance. The fault affects only one cylinder, but in winter it can make starting worse, so have it checked without rushing but not too late.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P06DF — Glow plug control module 1: memory checksum error
- Next code: P06E1 — Cylinder 11 glow plug control circuit: voltage too...
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault