Skip to content
Fault code dictionary (DTC)

P06E3 — Cylinder 12 glow plug control circuit: voltage too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control module detected a higher-than-expected voltage on the glow plug control circuit of cylinder 12, for example from contact with a live wire or from a break. This code applies to diesel engines with at least 12 cylinders, which are very rare. On an ordinary car, check that the reading and the cylinder numbering are correct.
FamilyPowertrain (P)

Typical symptoms

Check engine light or glow plug light on
Hard starting when cold
White or grey smoke after start-up
Uneven running of one cylinder in the first minutes
Glow plug not heating or heating abnormally

Common causes

Control wire in contact with a 12-volt wire
Broken circuit with the glow plug unplugged or failed
Connector with bent or corroded terminals
Wiring damaged by heat or chafing
Internal fault in the glow plug module

What to do

First check the wiring and connector of the indicated glow plug, then verify the glow plug resistance and wire continuity. The problem affects one cylinder only, but in winter it can make starting worse: better to have it checked sooner rather than later.

How to read code P06E3

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P06E3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (E3) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P06E3 mean?

Cylinder 12 glow plug control circuit: voltage too high. The control module detected a higher-than-expected voltage on the glow plug control circuit of cylinder 12, for example from contact with a live wire or from a break. This code applies to diesel engines with at least 12 cylinders, which are very rare. On an ordinary car, check that the reading and the cylinder numbering are correct.

Can I keep driving with code P06E3 active?

With caution: limp mode possible, have it checked soon

Common causes — P06E3

Control wire in contact with a 12-volt wire Broken circuit with the glow plug unplugged or failed Connector with bent or corroded terminals Wiring damaged by heat or chafing Internal fault in the glow plug module

How do you fix code P06E3?

First check the wiring and connector of the indicated glow plug, then verify the glow plug resistance and wire continuity. The problem affects one cylinder only, but in winter it can make starting worse: better to have it checked sooner rather than later.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes