P06E4 — Control module wake-up circuit: performance fault
| Meaning | Some control units stay "asleep" with the ignition off and are woken by a signal, for example when a door is opened or the key is inserted. The control unit detected that this wake-up circuit is not working as it should. Which signal is used and which module is involved depends on the manufacturer, so the wiring diagram for your brand is needed. |
| Family | Powertrain (P) |
Typical symptoms
Uncertain or delayed starting
Battery draining while parked
Other modules not waking up or staying on
Communication error messages on the dashboard
Common causes
Corroded or loose connectors
Weak battery or unstable supply voltage
Connected module not sending the signal correctly
Poor module ground
Internal fault in the control unit
What to do
How to read code P06E4
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P06E4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (E4) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P06E4 mean?
Control module wake-up circuit: performance fault. Some control units stay "asleep" with the ignition off and are woken by a signal, for example when a door is opened or the key is inserted. The control unit detected that this wake-up circuit is not working as it should. Which signal is used and which module is involved depends on the manufacturer, so the wiring diagram for your brand is needed.
Can I keep driving with code P06E4 active?
With caution: limp mode possible, have it checked soon
Common causes — P06E4
Wake-up signal wire broken or with high resistance Corroded or loose connectors Weak battery or unstable supply voltage Connected module not sending the signal correctly Poor module ground Internal fault in the control unit
How do you fix code P06E4?
First check the battery, terminals and grounds, because unstable voltage causes many of these codes. Then inspect the connectors and wiring of the wake-up circuit. If the car starts normally it can be used, but a battery that drains should not be ignored.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P06E3 — Cylinder 12 glow plug control circuit: voltage too...
- Next code: P06E5 — Glow plug control module 1: performance fault
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault