Skip to content
Fault code dictionary (DTC)

P06ED — Engine RPM output signal circuit low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected that the circuit it uses to send engine speed to other devices has too low a voltage. The signal may therefore not reach the tachometer or other control units correctly. The exact meaning depends on the manufacturer and model.
FamilyPowertrain (P)

Typical symptoms

Tachometer stuck or inaccurate
Check engine light on
Other control units reporting missing data
Irregular behavior of systems that use engine speed
No obvious symptom in some cases

Common causes

Signal wire shorted to ground
Damaged wiring or connector
Fault in the device receiving the signal
Internal fault in the engine control unit
Moisture or corrosion in the connectors

What to do

Have the wiring and connectors of the RPM signal checked and the signal verified with an oscilloscope or suitable tool. It is usually not extremely urgent, but it should be fixed because other systems may depend on that data.

How to read code P06ED

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P06ED starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (ED) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P06ED mean?

Engine RPM output signal circuit low. The control unit detected that the circuit it uses to send engine speed to other devices has too low a voltage. The signal may therefore not reach the tachometer or other control units correctly. The exact meaning depends on the manufacturer and model.

Can I keep driving with code P06ED active?

With caution: limp mode possible, have it checked soon

Common causes — P06ED

Signal wire shorted to ground Damaged wiring or connector Fault in the device receiving the signal Internal fault in the engine control unit Moisture or corrosion in the connectors

How do you fix code P06ED?

Have the wiring and connectors of the RPM signal checked and the signal verified with an oscilloscope or suitable tool. It is usually not extremely urgent, but it should be fixed because other systems may depend on that data.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes