P06EE — Engine RPM output signal circuit high
| Meaning | The control unit detected that the circuit it uses to send engine speed to other devices has too high a voltage. The signal may therefore be wrong for the tachometer or other control units. The exact meaning depends on the manufacturer and model. |
| Family | Powertrain (P) |
Typical symptoms
Check engine light on
Other control units reporting wrong data
Irregular behavior of systems that use engine speed
No obvious symptom in some cases
Common causes
Damaged wiring or connector
Fault in the device receiving the signal
Internal fault in the engine control unit
Moisture or corrosion in the connectors
What to do
How to read code P06EE
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P06EE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (EE) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P06EE mean?
Engine RPM output signal circuit high. The control unit detected that the circuit it uses to send engine speed to other devices has too high a voltage. The signal may therefore be wrong for the tachometer or other control units. The exact meaning depends on the manufacturer and model.
Can I keep driving with code P06EE active?
With caution: limp mode possible, have it checked soon
Common causes — P06EE
Signal wire shorted to the power supply Damaged wiring or connector Fault in the device receiving the signal Internal fault in the engine control unit Moisture or corrosion in the connectors
How do you fix code P06EE?
Have the wiring and connectors of the RPM signal checked and the voltage verified with a suitable tool. It is usually not extremely urgent, but it should be fixed because other systems may depend on that data.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P06ED — Engine RPM output signal circuit low
- Next code: P06EF — Engine restart performance fault (Stop-Start)
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault