P06FD — Glow plug module 2: faulty link with the engine control unit
| Meaning | The engine control unit found that its communication with the second glow plug control module is not behaving as expected: data is corrupted, late or out of range. A second module is fitted on some diesel engines, for example those with two cylinder banks. Which module counts as number 2 depends on the manufacturer. Cold-start preheating may therefore not work properly. |
| Family | Powertrain (P) |
Typical symptoms
White or grey smoke after starting in the morning
Glow plug light or check engine light on
Uneven idle during the first minutes
Noisier running when cold
Common causes
Damaged connector or wiring on the communication line
Faulty glow plug module
Poor ground connection at the module
Software or engine control unit problem (rare)
What to do
How to read code P06FD
This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.
The code P06FD starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (FD) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P06FD mean?
Glow plug module 2: faulty link with the engine control unit. The engine control unit found that its communication with the second glow plug control module is not behaving as expected: data is corrupted, late or out of range. A second module is fitted on some diesel engines, for example those with two cylinder banks. Which module counts as number 2 depends on the manufacturer. Cold-start preheating may therefore not work properly.
Can I keep driving with code P06FD active?
With caution: limp mode possible, have it checked soon
Common causes — P06FD
Low battery voltage or corroded power connections Damaged connector or wiring on the communication line Faulty glow plug module Poor ground connection at the module Software or engine control unit problem (rare)
How do you fix code P06FD?
First check the battery and the terminals, then the glow plug module connectors. If the car starts normally you can drive it with care, but cold starting will get worse as temperatures drop. Have it scanned soon, especially before winter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P06FC — Glow plug control module 2 to engine control unit...
- Next code: P06FE — Diesel cold start: intake air flow control not per...
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault