P07F3 — Range selector module communication circuit low
| Meaning | The control unit has detected that the communication signal to the transmission range control module, which handles the P, R, N, D selection, is sitting at a lower voltage than normal. The gearbox may therefore not reliably receive the gear you asked for. The exact way this link is built differs from one manufacturer to another. |
| Family | Powertrain (P) |
Typical symptoms
Gear selector that does not respond or responds late
Gear that will not engage or gearbox staying in neutral
Gearbox-related warning messages on the dashboard
Car that will not start or suddenly stops
Common causes
Communication wire touching ground
Weak battery or poor vehicle ground connection
Internal fault in the range control module
Problem on the communication network between control units
What to do
How to read code P07F3
This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.
The code P07F3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (F3) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07F3 mean?
Range selector module communication circuit low. The control unit has detected that the communication signal to the transmission range control module, which handles the P, R, N, D selection, is sitting at a lower voltage than normal. The gearbox may therefore not reliably receive the gear you asked for. The exact way this link is built differs from one manufacturer to another.
Can I keep driving with code P07F3 active?
With caution: limp mode possible, have it checked soon
Common causes — P07F3
Corroded or loose connector or wiring at the module Communication wire touching ground Weak battery or poor vehicle ground connection Internal fault in the range control module Problem on the communication network between control units
How do you fix code P07F3?
Start by checking the battery and its terminals, then the connectors and wiring at the range control module. Do not put it off: if the gearbox does not respond properly the car can be left stranded or behave unpredictably, so have the data read at a workshop soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07F2 — Transmission range control module communication ci...
- Next code: P07F4 — Range selector module communication circuit high
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible