P0A57 — Drive motor B current sensor signal too low
| Meaning | The control unit found that the signal from the drive motor B current sensor is below the minimum it expects. This often happens when the circuit is broken or shorted to ground, or when the sensor is not responding. What counts as motor B is defined by the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power when accelerating
Limited or no electric drive
Combustion engine works more than usual
Fault message on the display
Common causes
Short to ground in the sensor wiring
Corroded connector or loose terminals
Faulty current sensor
Missing or too low sensor supply
Inverter or control unit fault (rare)
What to do
How to read code P0A57
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0A57 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (57) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0A57 mean?
Drive motor B current sensor signal too low. The control unit found that the signal from the drive motor B current sensor is below the minimum it expects. This often happens when the circuit is broken or shorted to ground, or when the sensor is not responding. What counts as motor B is defined by the manufacturer.
Can I keep driving with code P0A57 active?
With caution: limp mode possible, have it checked soon
Common causes — P0A57
Broken or disconnected sensor wire Short to ground in the sensor wiring Corroded connector or loose terminals Faulty current sensor Missing or too low sensor supply Inverter or control unit fault (rare)
How do you fix code P0A57?
First check the condition of the sensor connector and wiring, and measure supply and ground with the right tool. Do not work on the orange high-voltage cables unless you are qualified. Have the car checked soon, especially if power drops.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0A56 — Drive motor B current sensor signal not plausible
- Next code: P0A58 — Drive motor B current sensor signal too high
Related codes
- P0A00 — Motor electronics coolant temperature sensor circuit fault
- P0A01 — Motor electronics coolant temperature sensor implausible
- P0A02 — Motor electronics coolant temperature sensor signal too low
- P0A03 — Motor electronics coolant temperature sensor signal too high
- P0A04 — Motor electronics coolant temperature sensor intermittent
- P0A05 — Motor electronics coolant pump control circuit open
- P0A06 — Motor electronics coolant pump control circuit low
- P0A07 — Motor electronics coolant pump control circuit high
- P0A08 — DC/DC converter status circuit fault
- P0A09 — DC/DC converter status signal too low
- P0A0A — High voltage system interlock circuit A fault
- P0A0B — High voltage interlock circuit A performance problem