P0A98 — Battery cooling fan 2 stuck on
| Meaning | The control unit has detected that battery cooling fan 2 stays on even when it has not been requested. The fan runs, so cooling is not missing, but the command or its monitoring is not behaving as intended. It is not an immediately dangerous fault, but it needs to be clarified. |
| Family | Powertrain (P) |
Typical symptoms
Blowing noise from the rear seat area
Hybrid system warning light on
Fan staying on with the car switched off
Faster discharge of the 12-volt battery
No other obvious driving symptoms
Common causes
A short circuit in the control wiring
A fault in the control unit or module driving the fan
Battery temperature sensor giving wrong values and calling for constant cooling
Battery temperature really high because of another problem
A control software error
What to do
How to read code P0A98
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0A98 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (98) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0A98 mean?
Battery cooling fan 2 stuck on. The control unit has detected that battery cooling fan 2 stays on even when it has not been requested. The fan runs, so cooling is not missing, but the command or its monitoring is not behaving as intended. It is not an immediately dangerous fault, but it needs to be clarified.
Can I keep driving with code P0A98 active?
With caution: limp mode possible, have it checked soon
Common causes — P0A98
Fan relay stuck in the closed position A short circuit in the control wiring A fault in the control unit or module driving the fan Battery temperature sensor giving wrong values and calling for constant cooling Battery temperature really high because of another problem A control software error
How do you fix code P0A98?
Check whether the fan stays on even with a cold battery and the car off: if so, the command is stuck. Have the system checked at a workshop within a reasonable time, because a fan that is always on uses energy and can drain the 12-volt battery. If the noise comes with temperature warnings, the priority goes up.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0A97 — Battery cooling fan 2: poor performance or stuck o...
- Next code: P0A99 — Battery cooling fan 2: control circuit low
Related codes
- P0A00 — Motor electronics coolant temperature sensor circuit fault
- P0A01 — Motor electronics coolant temperature sensor implausible
- P0A02 — Motor electronics coolant temperature sensor signal too low
- P0A03 — Motor electronics coolant temperature sensor signal too high
- P0A04 — Motor electronics coolant temperature sensor intermittent
- P0A05 — Motor electronics coolant pump control circuit open
- P0A06 — Motor electronics coolant pump control circuit low
- P0A07 — Motor electronics coolant pump control circuit high
- P0A08 — DC/DC converter status circuit fault
- P0A09 — DC/DC converter status signal too low
- P0A0A — High voltage system interlock circuit A fault
- P0A0B — High voltage interlock circuit A performance problem