Skip to content
Fault code dictionary (DTC)

P0D02 — Control Pilot ventilation switch circuit low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit read a lower voltage than expected on the Control Pilot ventilation switch circuit. It usually points to a wire shorted to ground or leaking to ground. Charging control may be disturbed as a result.
FamilyPowertrain (P)

Typical symptoms

Charging does not start or stops right away
Warning light for the charging system
Error shown by the charging station
Possibly a blown fuse on the circuit
No other symptom in normal driving

Common causes

Signal wire touching ground
Charge port with water or corrosion
Wiring pinched or worn through
Faulty on-board charger
Defective charging control unit

What to do

Look at the charge port for moisture, residue, or burn marks. Do not keep retrying charging if you notice a burning smell or unusual heat. Wiring checks should be done at a workshop with high-voltage equipment.

How to read code P0D02

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0D02 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0D02 mean?

Control Pilot ventilation switch circuit low. The control unit read a lower voltage than expected on the Control Pilot ventilation switch circuit. It usually points to a wire shorted to ground or leaking to ground. Charging control may be disturbed as a result.

Can I keep driving with code P0D02 active?

With caution: limp mode possible, have it checked soon

Common causes — P0D02

Signal wire touching ground Charge port with water or corrosion Wiring pinched or worn through Faulty on-board charger Defective charging control unit

How do you fix code P0D02?

Look at the charge port for moisture, residue, or burn marks. Do not keep retrying charging if you notice a burning smell or unusual heat. Wiring checks should be done at a workshop with high-voltage equipment.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes