Skip to content
Fault code dictionary (DTC)

P0D06 — Control Pilot ventilation switch stuck on

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit found that the Control Pilot ventilation switch stays active when it should be off. The charging station may therefore receive an unwanted ventilation request. Charging may be prevented or limited.
FamilyPowertrain (P)

Typical symptoms

Charging that does not start or is refused
Warning light for the charging system
Charging station reports an abnormal condition
Different behavior depending on the station
No symptom while driving

Common causes

Switch or relay inside the charger stuck closed
Short in the control circuit
Damaged wiring or connector
Defective charging control unit
Moisture in the charge port

What to do

Try another charging station and another cable, and check the port. If the code persists, a workshop check with high-voltage equipment is needed. Do not touch the orange cables.

How to read code P0D06

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0D06 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0D06 mean?

Control Pilot ventilation switch stuck on. The control unit found that the Control Pilot ventilation switch stays active when it should be off. The charging station may therefore receive an unwanted ventilation request. Charging may be prevented or limited.

Can I keep driving with code P0D06 active?

With caution: limp mode possible, have it checked soon

Common causes — P0D06

Switch or relay inside the charger stuck closed Short in the control circuit Damaged wiring or connector Defective charging control unit Moisture in the charge port

How do you fix code P0D06?

Try another charging station and another cable, and check the port. If the code persists, a workshop check with high-voltage equipment is needed. Do not touch the orange cables.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes