P0E86 — Battery charger B input voltage too low
| Meaning | The control unit measured a lower voltage than the required minimum at the input of charger B. The problem may be in the supply, the cable or the car. The charger may therefore not start or may stop. Which unit is B depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Charging does not start
Charging stops by itself
Charging error message
Slow charging
Common causes
Unsuitable or damaged charging cable or extension lead
Dirty or worn contacts on the socket or car inlet
Faulty charging post or wallbox
Car's internal wiring in poor condition
Sensor or charger fault
What to do
How to read code P0E86
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0E86 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0E86 mean?
Battery charger B input voltage too low. The control unit measured a lower voltage than the required minimum at the input of charger B. The problem may be in the supply, the cable or the car. The charger may therefore not start or may stop. Which unit is B depends on the manufacturer.
Can I keep driving with code P0E86 active?
With caution: limp mode possible, have it checked soon
Common causes — P0E86
Mains or socket with low voltage Unsuitable or damaged charging cable or extension lead Dirty or worn contacts on the socket or car inlet Faulty charging post or wallbox Car's internal wiring in poor condition Sensor or charger fault
How do you fix code P0E86?
Try charging from another socket or charging post with a different cable, avoiding extension leads. If the code appears everywhere, the problem is probably on the car and should be checked at a workshop. Also check that the contacts are not dirty or burnt.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0E85 — Battery charger B temperature too high
- Next code: P0E87 — Battery charger B input voltage too high
Related codes
- P0E00 — Generator phase U current sensor circuit fault
- P0E01 — Generator phase U current sensor out of range
- P0E02 — Generator phase U current sensor: signal too low
- P0E03 — Generator phase U current sensor: signal too high
- P0E04 — Generator phase V current sensor circuit fault
- P0E05 — Generator phase V current sensor: signal out of range
- P0E06 — Generator phase V current sensor: signal too low
- P0E07 — Generator phase V current sensor: signal too high
- P0E08 — Generator phase W current sensor circuit fault
- P0E09 — Generator phase W current sensor: signal out of range
- P0E0A — Generator phase W current sensor: signal too low
- P0E0B — Generator phase W current sensor: signal too high