Skip to content
Fault code dictionary (DTC)

P0E8E — Drive motor A inverter: voltage sensor B signal too low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe hybrid or electric control unit read a signal that is too low from voltage sensor B of the inverter serving drive motor A. The fault may be in the sensor or its wiring rather than in the inverter itself. Which motor is 'A' and which sensor is 'B' is set by the manufacturer, so check your vehicle's service information.
FamilyPowertrain (P)

Typical symptoms

Hybrid or EV system warning light on
Fault message on the dashboard
Reduced power or limp mode
Car won't start in electric mode
Engine running more than usual (on hybrids)

Common causes

Corroded or loose sensor connector
Damaged wiring or short to ground
Faulty voltage sensor
Internal inverter problem
Moisture inside the inverter assembly

What to do

This is a high-voltage circuit: don't touch the orange cables and don't open the inverter. Have a workshop with hybrid/EV-trained staff inspect it. If the car goes into reduced power, avoid long trips until it has been checked.

How to read code P0E8E

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0E8E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0E8E mean?

Drive motor A inverter: voltage sensor B signal too low. The hybrid or electric control unit read a signal that is too low from voltage sensor B of the inverter serving drive motor A. The fault may be in the sensor or its wiring rather than in the inverter itself. Which motor is 'A' and which sensor is 'B' is set by the manufacturer, so check your vehicle's service information.

Can I keep driving with code P0E8E active?

With caution: limp mode possible, have it checked soon

Common causes — P0E8E

Corroded or loose sensor connector Damaged wiring or short to ground Faulty voltage sensor Internal inverter problem Moisture inside the inverter assembly

How do you fix code P0E8E?

This is a high-voltage circuit: don't touch the orange cables and don't open the inverter. Have a workshop with hybrid/EV-trained staff inspect it. If the car goes into reduced power, avoid long trips until it has been checked.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes