P0EE9 — Charge port temperature sensor B: signal low
| Meaning | The control unit measured too low a voltage in the circuit of charge port temperature sensor B, which amounts to an unrealistically high temperature reading or a short to ground. The data is not reliable. Which point of the port is sensor B depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Charging slowed as protection
Warning light on
Charging error message
Port temperature read as very high even with a cold port
Common causes
Short-circuited sensor
Moisture in the connector or port
Crushed or damaged wiring
Faulty charging control unit
What to do
How to read code P0EE9
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0EE9 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0EE9 mean?
Charge port temperature sensor B: signal low. The control unit measured too low a voltage in the circuit of charge port temperature sensor B, which amounts to an unrealistically high temperature reading or a short to ground. The data is not reliable. Which point of the port is sensor B depends on the manufacturer.
Can I keep driving with code P0EE9 active?
With caution: limp mode possible, have it checked soon
Common causes — P0EE9
Sensor wire in contact with ground Short-circuited sensor Moisture in the connector or port Crushed or damaged wiring Faulty charging control unit
How do you fix code P0EE9?
Have the wiring and connector of sensor B checked, looking for moisture or damaged wires, then the sensor measured. If the port is cold and charging does not start, the problem is almost certainly electrical and not real overheating.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0EE8 — Charge port temperature sensor B: signal out of ra...
- Next code: P0EEA — Charge port temperature sensor B: signal high
Related codes
- P0E00 — Generator phase U current sensor circuit fault
- P0E01 — Generator phase U current sensor out of range
- P0E02 — Generator phase U current sensor: signal too low
- P0E03 — Generator phase U current sensor: signal too high
- P0E04 — Generator phase V current sensor circuit fault
- P0E05 — Generator phase V current sensor: signal out of range
- P0E06 — Generator phase V current sensor: signal too low
- P0E07 — Generator phase V current sensor: signal too high
- P0E08 — Generator phase W current sensor circuit fault
- P0E09 — Generator phase W current sensor: signal out of range
- P0E0A — Generator phase W current sensor: signal too low
- P0E0B — Generator phase W current sensor: signal too high