P0EEA — Charge port temperature sensor B: signal high
| Meaning | The control unit measured too high a voltage in the circuit of charge port temperature sensor B, which amounts to an unrealistically low temperature reading or an open circuit. The data is not reliable. Which point of the port is sensor B depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Charging limited as a precaution
Warning light on
Charging error message
Port temperature read as extremely low
Common causes
Disconnected connector or corroded terminals
Faulty sensor
Wiring damaged near the port
Faulty charging control unit
What to do
How to read code P0EEA
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0EEA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0EEA mean?
Charge port temperature sensor B: signal high. The control unit measured too high a voltage in the circuit of charge port temperature sensor B, which amounts to an unrealistically low temperature reading or an open circuit. The data is not reliable. Which point of the port is sensor B depends on the manufacturer.
Can I keep driving with code P0EEA active?
With caution: limp mode possible, have it checked soon
Common causes — P0EEA
Broken sensor wire Disconnected connector or corroded terminals Faulty sensor Wiring damaged near the port Faulty charging control unit
How do you fix code P0EEA?
Have the connector and wiring of sensor B checked, then the sensor measured with a suitable tool. If you notice signs of heat on the port, do not charge until it has been checked, because without a reliable sensor the thermal protection does not work properly.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0EE9 — Charge port temperature sensor B: signal low
- Next code: P0EEB — Charge port temperature sensor B: intermittent sig...
Related codes
- P0E00 — Generator phase U current sensor circuit fault
- P0E01 — Generator phase U current sensor out of range
- P0E02 — Generator phase U current sensor: signal too low
- P0E03 — Generator phase U current sensor: signal too high
- P0E04 — Generator phase V current sensor circuit fault
- P0E05 — Generator phase V current sensor: signal out of range
- P0E06 — Generator phase V current sensor: signal too low
- P0E07 — Generator phase V current sensor: signal too high
- P0E08 — Generator phase W current sensor circuit fault
- P0E09 — Generator phase W current sensor: signal out of range
- P0E0A — Generator phase W current sensor: signal too low
- P0E0B — Generator phase W current sensor: signal too high