P0EFA — Battery charger A input voltage sensor B signal high
| Meaning | The control unit detected a signal on the circuit of sensor B, which measures the input voltage to charger A, that is higher than allowed. It often points to a broken wire, an unplugged connector or a faulty sensor. The letters A and B identify a specific charger and sensor, and their exact meaning depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Charging not starting or being blocked
Charging at limited power
Charging error message
Input voltage read too high on the scan tool
Common causes
Faulty voltage sensor
Corroded connector contacts
Pulled or damaged wiring
Internal charger fault
What to do
How to read code P0EFA
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0EFA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0EFA mean?
Battery charger A input voltage sensor B signal high. The control unit detected a signal on the circuit of sensor B, which measures the input voltage to charger A, that is higher than allowed. It often points to a broken wire, an unplugged connector or a faulty sensor. The letters A and B identify a specific charger and sensor, and their exact meaning depends on the manufacturer.
Can I keep driving with code P0EFA active?
With caution: limp mode possible, have it checked soon
Common causes — P0EFA
Broken sensor wire or connector not seated Faulty voltage sensor Corroded connector contacts Pulled or damaged wiring Internal charger fault
How do you fix code P0EFA?
Check connectors and wiring, and try another outlet or charging station. If the code persists, have the charger checked. If you notice a burning smell, unusual heat or signs of melting, stop charging and have it checked right away.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0EF9 — Battery charger A input voltage sensor B signal lo...
- Next code: P0EFB — Battery charger A input voltage sensor C circuit f...
Related codes
- P0E00 — Generator phase U current sensor circuit fault
- P0E01 — Generator phase U current sensor out of range
- P0E02 — Generator phase U current sensor: signal too low
- P0E03 — Generator phase U current sensor: signal too high
- P0E04 — Generator phase V current sensor circuit fault
- P0E05 — Generator phase V current sensor: signal out of range
- P0E06 — Generator phase V current sensor: signal too low
- P0E07 — Generator phase V current sensor: signal too high
- P0E08 — Generator phase W current sensor circuit fault
- P0E09 — Generator phase W current sensor: signal out of range
- P0E0A — Generator phase W current sensor: signal too low
- P0E0B — Generator phase W current sensor: signal too high