P2473 — Exhaust temperature sensor circuit, bank 2 sensor 4
| Meaning | The control unit has found an electrical problem in the circuit of the exhaust gas temperature sensor labeled sensor 4 on bank 2. These sensors help control the particulate filter and its regeneration. The exact position of sensor 4 depends on the manufacturer. Bank 2 only exists on V engines or engines with two exhaust lines. |
| Family | Powertrain (P) |
Typical symptoms
Filter regeneration disturbed or not carried out
Loss of power or limp mode
Higher diesel consumption than usual
Common causes
Corroded or loose connector
Faulty temperature sensor
Short circuit or short to ground in the wiring
Rarely, a faulty engine control unit
What to do
How to read code P2473
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2473 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (73) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2473 mean?
Exhaust temperature sensor circuit, bank 2 sensor 4. The control unit has found an electrical problem in the circuit of the exhaust gas temperature sensor labeled sensor 4 on bank 2. These sensors help control the particulate filter and its regeneration. The exact position of sensor 4 depends on the manufacturer. Bank 2 only exists on V engines or engines with two exhaust lines.
Can I keep driving with code P2473 active?
With caution: limp mode possible, have it checked soon
Common causes — P2473
Sensor wiring damaged or too close to hot parts Corroded or loose connector Faulty temperature sensor Short circuit or short to ground in the wiring Rarely, a faulty engine control unit
How do you fix code P2473?
Check the sensor wiring and connector on bank 2, especially where it runs near the exhaust, looking for burnt insulation or loose wires. You can use the car for a short while, but the filter isn't being managed well, so have it checked soon. Don't clear the code without finding the cause.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2472 — Exhaust temperature sensor erratic, bank 1 sensor...
- Next code: P2474 — Exhaust temperature sensor range/performance, bank...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible