P2474 — Exhaust temperature sensor range/performance, bank 2 sensor 4
| Meaning | The control unit receives a temperature value from sensor 4 on bank 2 that looks fine as an electrical signal but does not agree with the other sensors or with engine conditions. The sensor may be dirty, aged or slow, or it may be reporting a real exhaust problem. |
| Family | Powertrain (P) |
Typical symptoms
Filter regeneration started early, late or interrupted
Occasional loss of power
Rising diesel consumption
Common causes
Exhaust leak near the sensor
Sensor loose or badly fitted
Wiring or connector with abnormal resistance
Filter or catalytic converter problem that alters temperatures
What to do
How to read code P2474
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2474 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (74) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2474 mean?
Exhaust temperature sensor range/performance, bank 2 sensor 4. The control unit receives a temperature value from sensor 4 on bank 2 that looks fine as an electrical signal but does not agree with the other sensors or with engine conditions. The sensor may be dirty, aged or slow, or it may be reporting a real exhaust problem.
Can I keep driving with code P2474 active?
With caution: limp mode possible, have it checked soon
Common causes — P2474
Aged or soot-coated temperature sensor Exhaust leak near the sensor Sensor loose or badly fitted Wiring or connector with abnormal resistance Filter or catalytic converter problem that alters temperatures
How do you fix code P2474?
Have the sensor and its connections on bank 2 checked, and make sure there are no exhaust leaks nearby. A workshop can compare the temperatures read by the different sensors to see whether this one is wrong. It isn't an emergency, but don't ignore it for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2473 — Exhaust temperature sensor circuit, bank 2 sensor...
- Next code: P2475 — Exhaust temperature sensor signal too low, bank 2...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible