P2475 — Exhaust temperature sensor signal too low, bank 2 sensor 4
| Meaning | The voltage on the circuit of sensor 4 on bank 2 is lower than normal, as if the sensor were reading a very cold temperature or the wire were shorted to ground. The control unit cannot rely on that reading to manage the particulate filter. |
| Family | Powertrain (P) |
Typical symptoms
Filter regeneration not carried out or abnormal
Loss of power or limp mode
Higher diesel consumption
Common causes
Wet, corroded or damaged connector
Faulty temperature sensor
Wiring crushed or burnt near the exhaust
Rarely, a faulty engine control unit
What to do
How to read code P2475
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2475 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (75) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2475 mean?
Exhaust temperature sensor signal too low, bank 2 sensor 4. The voltage on the circuit of sensor 4 on bank 2 is lower than normal, as if the sensor were reading a very cold temperature or the wire were shorted to ground. The control unit cannot rely on that reading to manage the particulate filter.
Can I keep driving with code P2475 active?
With caution: limp mode possible, have it checked soon
Common causes — P2475
Sensor wire touching ground Wet, corroded or damaged connector Faulty temperature sensor Wiring crushed or burnt near the exhaust Rarely, a faulty engine control unit
How do you fix code P2475?
Check the sensor wiring and connector on bank 2, looking for moisture, corrosion or damaged insulation. If the filter can't regenerate properly it may clog, so have the system checked without waiting too long. Don't clear the code without repairing the cause.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2474 — Exhaust temperature sensor range/performance, bank...
- Next code: P2476 — Exhaust temperature sensor signal too high, bank 2...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible