Skip to content
Fault code dictionary (DTC)

P2476 — Exhaust temperature sensor signal too high, bank 2 sensor 4

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe voltage on the circuit of sensor 4 on bank 2 is higher than normal. The control unit reads this as a very high temperature or as a wire that is broken or shorted to the supply. The reading cannot be trusted to control the particulate filter.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Filter regeneration abnormal or blocked
Loss of power or limp mode
Fan or exhaust seeming to work harder than they should

Common causes

Sensor wire broken or pulled out of the connector
Wiring shorted to the supply
Faulty temperature sensor
Corroded connector or bent pins
Rarely, a faulty engine control unit

What to do

Start with the connector and wiring of the sensor on bank 2, making sure no wire is broken or out of place. If the real temperature were actually high because of another fault, stop if you smell burning or feel strong heat. In any case, have it checked soon.

How to read code P2476

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2476 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (76) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2476 mean?

Exhaust temperature sensor signal too high, bank 2 sensor 4. The voltage on the circuit of sensor 4 on bank 2 is higher than normal. The control unit reads this as a very high temperature or as a wire that is broken or shorted to the supply. The reading cannot be trusted to control the particulate filter.

Can I keep driving with code P2476 active?

With caution: limp mode possible, have it checked soon

Common causes — P2476

Sensor wire broken or pulled out of the connector Wiring shorted to the supply Faulty temperature sensor Corroded connector or bent pins Rarely, a faulty engine control unit

How do you fix code P2476?

Start with the connector and wiring of the sensor on bank 2, making sure no wire is broken or out of place. If the real temperature were actually high because of another fault, stop if you smell burning or feel strong heat. In any case, have it checked soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes