P24B5 — Particulate sensor heater control circuit low
| Meaning | The engine computer found that the circuit powering the particulate matter sensor heater has a lower voltage than normal. This usually points to a wire shorted to ground, a bad contact or a failed heater. Without the heater the sensor cannot clean itself and cannot monitor the particulate filter properly. |
| Family | Powertrain (P) |
Typical symptoms
Warning message about the emissions system
Possible additional codes for the particulate sensor
Usually no obvious difference while driving
Possible power limitation on some models
Common causes
Corroded or wet connector
Heater inside the sensor shorted
Wiring pinched or chafed near the exhaust
Driver fault in the computer, which is rare
What to do
How to read code P24B5
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24B5 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (B5) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24B5 mean?
Particulate sensor heater control circuit low. The engine computer found that the circuit powering the particulate matter sensor heater has a lower voltage than normal. This usually points to a wire shorted to ground, a bad contact or a failed heater. Without the heater the sensor cannot clean itself and cannot monitor the particulate filter properly.
Can I keep driving with code P24B5 active?
With caution: limp mode possible, have it checked soon
Common causes — P24B5
Heater wire shorted to ground from damaged insulation Corroded or wet connector Heater inside the sensor shorted Wiring pinched or chafed near the exhaust Driver fault in the computer, which is rare
How do you fix code P24B5?
Have the sensor wiring and connector checked first, especially where the cable runs near hot or moving parts. You can keep driving, but it is best to have it looked at soon because the filter is no longer monitored correctly.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24B4 — Particulate sensor heater control circuit range/pe...
- Next code: P24B6 — Particulate sensor heater control circuit high
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible