P24B6 — Particulate sensor heater control circuit high
| Meaning | The engine computer found a higher voltage than normal in the control circuit of the particulate matter sensor heater. It can be caused by a broken wire, an open contact or a short to the power supply. The heater does not work properly and the monitoring of the particulate filter is compromised. |
| Family | Powertrain (P) |
Typical symptoms
Warning message about the emissions system
Possible other codes related to the particulate filter
Usually no obvious driving problem
Possible reduced mode on some vehicles
Common causes
Short to power supply in the wiring
Open heater inside the sensor
Corroded or bent terminals in the connector
Internal computer fault, which is rare
What to do
How to read code P24B6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24B6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (B6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24B6 mean?
Particulate sensor heater control circuit high. The engine computer found a higher voltage than normal in the control circuit of the particulate matter sensor heater. It can be caused by a broken wire, an open contact or a short to the power supply. The heater does not work properly and the monitoring of the particulate filter is compromised.
Can I keep driving with code P24B6 active?
With caution: limp mode possible, have it checked soon
Common causes — P24B6
Broken heater wire or disconnected connector Short to power supply in the wiring Open heater inside the sensor Corroded or bent terminals in the connector Internal computer fault, which is rare
How do you fix code P24B6?
Have the sensor wiring and connector checked, verifying continuity and the absence of shorts. It is not an emergency, but do not put it off for long, because the filter monitoring is unreliable while the fault is active.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24B5 — Particulate sensor heater control circuit low
- Next code: P24B7 — Particulate sensor heater resistance out of range
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible