P24B7 — Particulate sensor heater resistance out of range
| Meaning | The engine computer measured a resistance of the particulate matter sensor heater that is outside the expected values. This usually means an aged or damaged heater, or a connection with abnormal resistance. The sensor may not reach the right temperature to clean itself and may give incorrect readings. |
| Family | Powertrain (P) |
Typical symptoms
Warning message about the emissions system
Possible codes for the sensor or the particulate filter
Often no driving symptoms
Possible performance limitation on some cars
Common causes
Connector with corroded contacts that raise the resistance
Damaged or poorly repaired wiring
Sensor dirty or damaged by impact or heat
Computer problem, which is rare
What to do
How to read code P24B7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24B7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (B7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24B7 mean?
Particulate sensor heater resistance out of range. The engine computer measured a resistance of the particulate matter sensor heater that is outside the expected values. This usually means an aged or damaged heater, or a connection with abnormal resistance. The sensor may not reach the right temperature to clean itself and may give incorrect readings.
Can I keep driving with code P24B7 active?
With caution: limp mode possible, have it checked soon
Common causes — P24B7
Degraded or damaged sensor heater Connector with corroded contacts that raise the resistance Damaged or poorly repaired wiring Sensor dirty or damaged by impact or heat Computer problem, which is rare
How do you fix code P24B7?
Have the connector checked and the heater resistance measured with the proper equipment. If the values are out of specification, the sensor usually needs replacing. You do not need to stop at once, but do not wait too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24B6 — Particulate sensor heater control circuit high
- Next code: P24B8 — EVAP leak detection pump pressure sensor circuit
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible