P24C8 — Particulate sensor temperature circuit signal too low
| Meaning | The control unit read a lower voltage than expected in the circuit that monitors the temperature of the particulate matter (soot) sensor, which sits downstream of the particulate filter. This usually points to a wire shorted to ground, a break in the wiring, or a failed sensor. While the fault remains, the system cannot monitor the filter properly. |
| Family | Powertrain (P) |
Typical symptoms
Possible emissions system fault message
More frequent filter regenerations than usual
Slightly uneven fuel use, or reduced engine power on some models
No obvious driving symptoms in many cases
Common causes
Corroded connector or water in the connector
Failed particulate matter sensor
Heat or vibration damaging the wire near the exhaust
Faulty sensor module or engine control unit (rare)
What to do
How to read code P24C8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24C8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (C8) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24C8 mean?
Particulate sensor temperature circuit signal too low. The control unit read a lower voltage than expected in the circuit that monitors the temperature of the particulate matter (soot) sensor, which sits downstream of the particulate filter. This usually points to a wire shorted to ground, a break in the wiring, or a failed sensor. While the fault remains, the system cannot monitor the filter properly.
Can I keep driving with code P24C8 active?
With caution: limp mode possible, have it checked soon
Common causes — P24C8
Damaged, pinched or grounded sensor wiring Corroded connector or water in the connector Failed particulate matter sensor Heat or vibration damaging the wire near the exhaust Faulty sensor module or engine control unit (rare)
How do you fix code P24C8?
Have the connector and wiring of the sensor checked first; it is mounted in the exhaust after the filter. You can drive a short distance, but don't leave it for long, because the filter is not being monitored correctly.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24C7 — Particulate sensor temperature circuit range/perfo...
- Next code: P24C9 — Particulate sensor temperature circuit signal too...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible