P24D4 — EGR cooler coolant pump feedback circuit fault
| Meaning | The control unit monitors the pump that circulates coolant through the exhaust gas recirculation (EGR) cooler. It detected that the pump's feedback signal is not correct. Without good cooling, the EGR system may work badly or be restricted. |
| Family | Powertrain (P) |
Typical symptoms
Possible overheating of the EGR system or coolant
Reduced power or limp mode
Unusual smoke or smell from the exhaust in some cases
Higher than normal emissions
Common causes
Damaged pump wiring or connector
Fuse or relay problem for the pump
Air in the cooling circuit or low coolant level
Faulty control unit or pump driver (rare)
What to do
How to read code P24D4
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24D4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (D4) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24D4 mean?
EGR cooler coolant pump feedback circuit fault. The control unit monitors the pump that circulates coolant through the exhaust gas recirculation (EGR) cooler. It detected that the pump's feedback signal is not correct. Without good cooling, the EGR system may work badly or be restricted.
Can I keep driving with code P24D4 active?
With caution: limp mode possible, have it checked soon
Common causes — P24D4
Faulty or seized EGR cooler pump Damaged pump wiring or connector Fuse or relay problem for the pump Air in the cooling circuit or low coolant level Faulty control unit or pump driver (rare)
How do you fix code P24D4?
First check the coolant level and that the pump is running. If you see a high temperature, stop and do not keep driving. This code is not defined identically by all manufacturers, so a brand-specific diagnosis is needed.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24D3 — AdBlue heater B sense circuit fault
- Next code: P24D5 — EVAP system pressure sensor B circuit fault
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible