Skip to content
Fault code dictionary (DTC)

P24D5 — EVAP system pressure sensor B circuit fault

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit found an electrical problem in the circuit of pressure sensor or switch B of the EVAP system, which recovers fuel vapour from the tank. The code points to a general circuit fault, not a specific leak. Without that data the control unit cannot check the system for leaks.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Slight fuel smell in some cases
Failed inspection or emissions test
Difficult refuelling or pump that keeps clicking off
No change in driving

Common causes

Damaged sensor connector or wiring
Faulty EVAP pressure sensor
Fuel cap not closed properly
Problem with the EVAP valve or hose
Faulty control unit (rare)

What to do

First check that the fuel cap is closed properly and in good condition, then have the connector and sensor checked. You can usually keep driving, but the fault needs fixing to pass emissions checks.

How to read code P24D5

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P24D5 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (D5) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P24D5 mean?

EVAP system pressure sensor B circuit fault. The control unit found an electrical problem in the circuit of pressure sensor or switch B of the EVAP system, which recovers fuel vapour from the tank. The code points to a general circuit fault, not a specific leak. Without that data the control unit cannot check the system for leaks.

Can I keep driving with code P24D5 active?

With caution: limp mode possible, have it checked soon

Common causes — P24D5

Damaged sensor connector or wiring Faulty EVAP pressure sensor Fuel cap not closed properly Problem with the EVAP valve or hose Faulty control unit (rare)

How do you fix code P24D5?

First check that the fuel cap is closed properly and in good condition, then have the connector and sensor checked. You can usually keep driving, but the fault needs fixing to pass emissions checks.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes