P24D6 — EVAP pressure sensor B signal out of range or implausible
| Meaning | EVAP pressure sensor B is sending the control unit a value that does not match what is expected. The circuit works, but the data is not plausible. It can come from the sensor, a leak in the system or a blocked hose. |
| Family | Powertrain (P) |
Typical symptoms
Slight fuel smell
Failed inspection or emissions check
Pump clicking off too early when refuelling
No clear driving symptoms
Common causes
Faulty or dirty EVAP pressure sensor
Cracked, pinched or blocked EVAP hoses
Stuck purge or vent valve
Problem with the vapour canister or filter (less common)
What to do
How to read code P24D6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24D6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (D6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24D6 mean?
EVAP pressure sensor B signal out of range or implausible. EVAP pressure sensor B is sending the control unit a value that does not match what is expected. The circuit works, but the data is not plausible. It can come from the sensor, a leak in the system or a blocked hose.
Can I keep driving with code P24D6 active?
With caution: limp mode possible, have it checked soon
Common causes — P24D6
Worn or poorly closed fuel cap Faulty or dirty EVAP pressure sensor Cracked, pinched or blocked EVAP hoses Stuck purge or vent valve Problem with the vapour canister or filter (less common)
How do you fix code P24D6?
Start with the fuel cap, then have the hoses and valves of the EVAP system inspected. It is usually not urgent for driving, but leaving it can worsen emissions.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24D5 — EVAP system pressure sensor B circuit fault
- Next code: P24D7 — EVAP pressure sensor B signal too low
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible