P24D7 — EVAP pressure sensor B signal too low
| Meaning | The control unit reads too low a voltage from EVAP pressure sensor B. This usually happens because of a wire shorted to ground, a short in the circuit or a faulty sensor. The fuel vapour leak check cannot run. |
| Family | Powertrain (P) |
Typical symptoms
Slight fuel smell in some cases
Failed emissions check
Difficult refuelling
No obvious change in driving
Common causes
Corroded connector or water in the connector
Faulty EVAP pressure sensor
Missing sensor power supply
Faulty control unit (rare)
What to do
How to read code P24D7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24D7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (D7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24D7 mean?
EVAP pressure sensor B signal too low. The control unit reads too low a voltage from EVAP pressure sensor B. This usually happens because of a wire shorted to ground, a short in the circuit or a faulty sensor. The fuel vapour leak check cannot run.
Can I keep driving with code P24D7 active?
With caution: limp mode possible, have it checked soon
Common causes — P24D7
Sensor wire grounded or pinched Corroded connector or water in the connector Faulty EVAP pressure sensor Missing sensor power supply Faulty control unit (rare)
How do you fix code P24D7?
Have the sensor wiring and connector checked; it is often near the fuel tank and can pick up water or dirt. You can usually keep driving, but the fault should be fixed for emissions reasons.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24D6 — EVAP pressure sensor B signal out of range or impl...
- Next code: P24D8 — EVAP pressure sensor B signal too high
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible