P24D8 — EVAP pressure sensor B signal too high
| Meaning | The control unit reads too high a voltage from EVAP pressure sensor B. The wire may be open, touching a power supply, or the sensor may be faulty. The leak check of the vapour system is not reliable. |
| Family | Powertrain (P) |
Typical symptoms
Slight fuel smell
Failed inspection or emissions check
Difficult refuelling
No obvious driving symptoms
Common causes
Corroded or loose terminals
Wire touching a power supply
Faulty EVAP pressure sensor
Faulty control unit (rare)
What to do
How to read code P24D8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24D8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (D8) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24D8 mean?
EVAP pressure sensor B signal too high. The control unit reads too high a voltage from EVAP pressure sensor B. The wire may be open, touching a power supply, or the sensor may be faulty. The leak check of the vapour system is not reliable.
Can I keep driving with code P24D8 active?
With caution: limp mode possible, have it checked soon
Common causes — P24D8
Broken sensor wire or unplugged connector Corroded or loose terminals Wire touching a power supply Faulty EVAP pressure sensor Faulty control unit (rare)
How do you fix code P24D8?
Check that the sensor connector is seated properly and free of corrosion, then have the wiring and sensor checked. You can usually keep driving, but the problem should be fixed.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24D7 — EVAP pressure sensor B signal too low
- Next code: P24D9 — EVAP pressure sensor B signal intermittent
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible