P24D9 — EVAP pressure sensor B signal intermittent
| Meaning | The signal from EVAP pressure sensor B reaches the control unit unevenly. The fault shows up from time to time, often because of an unstable contact in the connector or wiring. It can disappear and return without a clear pattern. |
| Family | Powertrain (P) |
Typical symptoms
Occasional slight fuel smell
Emissions check failed at certain times
Problem more frequent in rain or on rough roads
No obvious effect on driving
Common causes
Partly broken or chafed wire
Water getting into the connector
EVAP pressure sensor starting to fail
Fuel cap that does not always close properly (less common)
What to do
How to read code P24D9
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24D9 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (D9) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24D9 mean?
EVAP pressure sensor B signal intermittent. The signal from EVAP pressure sensor B reaches the control unit unevenly. The fault shows up from time to time, often because of an unstable contact in the connector or wiring. It can disappear and return without a clear pattern.
Can I keep driving with code P24D9 active?
With caution: limp mode possible, have it checked soon
Common causes — P24D9
Loose or corroded connector Partly broken or chafed wire Water getting into the connector EVAP pressure sensor starting to fail Fuel cap that does not always close properly (less common)
How do you fix code P24D9?
Have the sensor connector and wiring checked, gently moving them to look for unstable contacts. It is not an emergency, but intermittent faults tend to become permanent.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24D8 — EVAP pressure sensor B signal too high
- Next code: P24DA — Particulate sensor exhaust sample error, bank 1
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible