P24EC — NH3 sensor supply voltage high
| Meaning | The control module measures a supply voltage that is too high at the NH3 sensor (the ammonia sensor after the SCR catalyst). This usually points to a short to a higher voltage, a ground problem or a fault in the circuit that powers the sensor. |
| Family | Powertrain (P) |
Typical symptoms
SCR system fault message
Possible power limitation
NH3 sensor signal missing or wrong
No obvious driving symptoms apart from the warning lights
Common causes
Sensor ground broken or corroded
Damaged or loose connector
Faulty NH3 sensor
Fault in the control unit or the regulator that powers the sensor
What to do
How to read code P24EC
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24EC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (EC) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24EC mean?
NH3 sensor supply voltage high. The control module measures a supply voltage that is too high at the NH3 sensor (the ammonia sensor after the SCR catalyst). This usually points to a short to a higher voltage, a ground problem or a fault in the circuit that powers the sensor.
Can I keep driving with code P24EC active?
With caution: limp mode possible, have it checked soon
Common causes — P24EC
Supply wire shorted to a higher voltage Sensor ground broken or corroded Damaged or loose connector Faulty NH3 sensor Fault in the control unit or the regulator that powers the sensor
How do you fix code P24EC?
Check that the sensor connector, wiring and ground are in good condition. Have the fault checked within a reasonable time, because an abnormal voltage can also damage other connected components.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24EB — NH3 sensor supply voltage low
- Next code: P24ED — NH3 sensor calibration memory error
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible