P24ED — NH3 sensor calibration memory error
| Meaning | The control module has found an error in the calibration data stored for the NH3 sensor (the ammonia sensor after the SCR catalyst). This data is used to interpret the signal correctly. Where it is stored (in the sensor or in the control unit) depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
SCR system fault message
Possible power limitation
Inaccurate AdBlue dosing
No obvious driving symptoms apart from the warning lights
Common causes
NH3 sensor replaced without the matching procedure
Faulty NH3 sensor with defective internal memory
Power supply problem while data was being written
Control unit fault or outdated software
What to do
How to read code P24ED
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24ED starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (ED) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24ED mean?
NH3 sensor calibration memory error. The control module has found an error in the calibration data stored for the NH3 sensor (the ammonia sensor after the SCR catalyst). This data is used to interpret the signal correctly. Where it is stored (in the sensor or in the control unit) depends on the manufacturer.
Can I keep driving with code P24ED active?
With caution: limp mode possible, have it checked soon
Common causes — P24ED
Corrupted calibration data in memory NH3 sensor replaced without the matching procedure Faulty NH3 sensor with defective internal memory Power supply problem while data was being written Control unit fault or outdated software
How do you fix code P24ED?
If the sensor or control unit was replaced recently, check that the manufacturer's matching procedure was carried out. Otherwise a diagnosis with suitable tools is needed, and it should not be postponed for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24EC — NH3 sensor supply voltage high
- Next code: P24EE — NH3 sensor processor performance fault
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible