P24EE — NH3 sensor processor performance fault
| Meaning | The control module has detected a fault in the internal electronics of the NH3 sensor (the ammonia sensor after the SCR catalyst), or in the processing of its signal. The exact meaning can vary from one manufacturer to another. |
| Family | Powertrain (P) |
Typical symptoms
SCR system fault message
Possible power limitation
NH3 sensor signal missing or inconsistent
No obvious driving symptoms apart from the warning lights
Common causes
Unstable sensor power supply or ground
Connector or wiring with faulty contacts
Communication problems between sensor and control unit
Control unit fault or outdated software
What to do
How to read code P24EE
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24EE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (EE) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24EE mean?
NH3 sensor processor performance fault. The control module has detected a fault in the internal electronics of the NH3 sensor (the ammonia sensor after the SCR catalyst), or in the processing of its signal. The exact meaning can vary from one manufacturer to another.
Can I keep driving with code P24EE active?
With caution: limp mode possible, have it checked soon
Common causes — P24EE
Faulty internal electronics in the NH3 sensor Unstable sensor power supply or ground Connector or wiring with faulty contacts Communication problems between sensor and control unit Control unit fault or outdated software
How do you fix code P24EE?
First check the sensor's power supply, ground and connector, which are the simplest causes to rule out. If they are fine, a diagnosis with suitable tools is needed, without too much delay.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24ED — NH3 sensor calibration memory error
- Next code: P24EF — Control module wake-up circuit open
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible