P24EF — Control module wake-up circuit open
| Meaning | The control module has detected a problem in the wake-up circuit, the signal that activates it when the ignition is switched on or the car is unlocked. This code is generic and does not by itself say which control unit is involved. The module concerned and how it is wired depend on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Control unit that does not wake up or wakes up late
Difficult or irregular starting
Battery draining more than usual
Other communication codes between control units
Common causes
Broken wake-up signal wire
Faulty fuse or power relay
Weak battery or unstable voltage
Fault in the control unit concerned
What to do
How to read code P24EF
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24EF starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (EF) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24EF mean?
Control module wake-up circuit open. The control module has detected a problem in the wake-up circuit, the signal that activates it when the ignition is switched on or the car is unlocked. This code is generic and does not by itself say which control unit is involved. The module concerned and how it is wired depend on the manufacturer.
Can I keep driving with code P24EF active?
With caution: limp mode possible, have it checked soon
Common causes — P24EF
Corroded or loose control unit connector Broken wake-up signal wire Faulty fuse or power relay Weak battery or unstable voltage Fault in the control unit concerned
How do you fix code P24EF?
First check the battery, the fuses and the connector of the control unit involved. Also have the other stored codes read, because they help identify which module is affected. Don't delay long if the car has starting difficulties.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24EE — NH3 sensor processor performance fault
- Next code: P24F0 — Control module wake-up circuit signal too low
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible