P24F0 — Control module wake-up circuit signal too low
| Meaning | The control module found that the wire that wakes it up (for example when the ignition is switched on, or when another module asks for it) is at a lower voltage than expected. The exact circuit differs from one manufacturer to another. Either way, the module may not wake up or start up properly. |
| Family | Powertrain (P) |
Typical symptoms
Check engine light on
Other modules not communicating or showing faults at the same time
Instrument cluster waking up late or intermittently
Battery going flat while the car is parked
Common causes
Corroded or loose connector, or damaged terminals
Low battery voltage, or poor power supplies and grounds at the module
Fault in the control module or in the module that sends the wake-up signal
Faulty fuse or relay in the power supply
What to do
How to read code P24F0
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24F0 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (F0) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24F0 mean?
Control module wake-up circuit signal too low. The control module found that the wire that wakes it up (for example when the ignition is switched on, or when another module asks for it) is at a lower voltage than expected. The exact circuit differs from one manufacturer to another. Either way, the module may not wake up or start up properly.
Can I keep driving with code P24F0 active?
With caution: limp mode possible, have it checked soon
Common causes — P24F0
Signal wire broken or shorted to ground Corroded or loose connector, or damaged terminals Low battery voltage, or poor power supplies and grounds at the module Fault in the control module or in the module that sends the wake-up signal Faulty fuse or relay in the power supply
How do you fix code P24F0?
Start with the battery: check the voltage is healthy and the terminals are clean and tight. Then have the fuses, grounds and connectors of the module checked. If the car is hard to start, don't leave it for long, because it can leave you stranded.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24EF — Control module wake-up circuit open
- Next code: P24F1 — Control module wake-up circuit signal too high
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible